Extend the life of your equipment and have a piece of mind knowing your gear is in top shape. Our commercial fuel polishing systems remove sludge, rust, and microbial contamination to less than two microns. Fuel Tech's process removes water to less than 100 PPM. The days of old-time filters and gravity water separators are over. 

It prevents your fuel from going bad and helps prevent your engine and generator from breaking down. Fuel starvation can block your engine's filter. Dirty, spoiled fuel can clog your filter when you need it most. Make sure you know what's in your fuel tank. Fuel polishing achieves this by capturing water, microbes, rust, and sludge in the filter system, eliminating the contaminants.

Fuel Tec's pneumatic fuel polishing systems can safely purify all fuels, including gasoline, ethanol blends, diesel, and jet fuel. Our high-tech pneumatic systems can remediate phase-separated ethanol blended gasoline. If you have any questions about our services, don't hesitate to get in touch with us.

FUELSTAT® is an immunoassay antibody fuel test for microbial contamination in diesel and jet fuels. It is simple to do, requires minimal instruction, and uses technology where a fast and dependable result is obtained in 10 minutes, no matter the dirty site conditions. The test can be done right at the fuel tank, so the fuel being analyzed does not require to be transported to a testing location, minimizing delays and opportunities for cross-contamination.

 Microbial contamination in hydrocarbon fuel can be a severe problem for storage tanks and equipment. It can cause severe fuel storage tank corrosion and corrosion in pumps and injectors. It will clog filters, fuel lines, and gauges and cause seals, hoses, and connections to swell and blister. These microbes must be detected and eliminated to avoid problems with the fuel supply. Early contamination detection protects the fuel supply quality and prevents waste.

 Biobor MD (Marine Diesel) is a cutting-edge over-the-road fuel conditioner engineered to enhance fuel performance, increase fuel lubricity and lower the cold pouring point(CFPP) by up to 25 degrees Fahrenheit. Biobor MD increases the cetane level for easier cold starting and cleans the entire system of sludge. Treating your fuel regularly with Biobor MD provides more available horsepower, torque, and fuel economy while reducing up to 94% of soot output and carbon buildup.

Biobor JF has been the most widely used and recommended fuel biocide and lubricity additive for over 56 years. Explicitly recommended by numerous major diesel engine manufacturers, Biobor JF will eliminate and prevent microbial growth in your fuel and dramatically increase the life of your filters. Additionally, Biobor JF adds lubricity back to ULSD, protecting your injectors and fuel pumps while preventing corrosion. For the life of your engine and the quality of your fuel, trust Biobor.

Biobor EB is a complete fuel treatment for use in all gasoline and ethanol-blended fuels. Great for use in any 2-cycle or 4-cycle gasoline engine, Biobor EB protects vital engine components while promoting a more efficient, better-running engine. With the introduction of ethanol in today's gasoline at up to 15%, Biobor EB will combat the corrosion and phase separation issues that arise while stabilizing fuel for storage and removing performance-robbing deposits and varnish.